To configure the TOYOTA 820/850/860/9000 machines with Wilcom using Stitch Manager or Machine Manager:

Stitch Manger -

Select Special-> Hardware Setup-> Direct Machine Connection to configure the TOYOTA connection.

Machine Manager -

Machine Manager configuration is done when selecting File-> Stitch to Machine Manager the first time. Machine Manager is the preferred method, especially with Windows 2000 and XP. Refer to the Machine Manager user manual for more details.

For Stitch Manager and Machine Manager, use the following parameters depending on how your TOYOTA is configured –

Machine format:

TOYOTA  

Protocol:

TOYOTA Serial

Baud Rate

8-data bits
2-stop bits
Parity

- odd

Handshaking

- Hardware

Alternative:

Machine format:

TOYOTA

Protocol:

TOYOTA Serial

Baud Rate

- 9600

8-data bits
2-stop bits
Parity

- none

Handshaking

– Embroidery Machine

Using the TOYOTA machine control panel to prepare for design input

Buttons on 820/830/850/860/9000 control panel-

When powering up the machine press SET to home machine.

1. (For 820 only) Press the Clear button
2. Send from Wilcom using Machine Manager or Stitch Manager.
3. Go to TOYOTA DATA BUTTON- choose input.
4. 00 shows - put 1 (for each next design the TOYOTA selects the next available memory slot. (see notes below).
5. Press the Set key.
6. Percentage transmitted should display in Wilcom Stitch Manager. In Machine Manager the progress bar displays output when Downloading appears. You should see a blinking LED light on the TOYOTA .

Note:

If you are using Wilcom for the first time with your TOYOTA, you must clear out any designs prior to transmitting when designs in the machine are from other software. This is a onetime process. If you continue using Wilcom, you do not need to clear out the TOYOTA. Always store as job #1. Sending the next design requires preparing the TOYOTA machine to accept the next design.

Note:

The machine won’t accept transmission if slot one is not open prior to transmitting.

In Machine Manager when TOYOTA Serial is selected, sending the next design requires preparing the Toyota machine to accept the next design. In Machine Manager with Toyota Serial, the "Send Next Design" icon on the toolbar is grayed out due to the Auto Download being selected in the Embroidery Machine Connection dialog box. Users are not able to disable this feature when using TOYOTA Serial.

You must always select #1 for input each time. As you prepare the TOYOTA for each design, the next design in the Machine Manager queue is automatically sent to the machine. Do this for each design. One by one they are loaded into the next available slot on the machine, even though you select #1 for every design.

For 25-pin TOYOTA ports, refer to the pin out chart at the following link.
For 9-25 pinout type "U" on chart.

http://www.wilcom.com.au/support/

Select Overview of Machine Connections. TOYOTA 850 may come with two, D-Sub to modular converters. A 9-9 pin straight through cat-5 RJ-45 connects to the two adapters.

This would be supplied with TOYOTA machine. The same 9-pin to 9-pin pinout would apply in the adapters.

TOYOTA 9-pin serial cable pinout-

9-pin Female to 9-pin Female